Hardware & Firmware Engineering
- PCB design & schematic capture
- ESP32 & Nordic BLE on FreeRTOS/Zephyr
- Power-optimized drivers & secure OTA
Bare-metal & RTOS · CAN / I2C / SPI / UART / SAE-J1939
From signal to shipped product.
A Chhatarpur-based engineering studio building hardware and embedded firmware, connected devices, and computer-vision systems — carried from concept through production, not handed off halfway.
§01 — CAPABILITIES
IoT & Connected Systems
- Sensor gateways & cloud telemetry
- WiFi-provisioned devices
- Live dashboards, device↔cloud commands
ESP32 · MQTT · Firebase / cloud IoT · BLE
Computer Vision & AI
- Camera calibration, detection & tracking
- Measurement algorithms
- Edge & cloud inference pipelines
From wheel alignment to liveness detection
§02 — WHY ENDDRAVE
Concept to production, one team.
Enddrave is a solo-founder engineering studio run by Bhupendra Kumar Gupta, Director & CTO — an M.Tech Gold Medalist in Embedded Systems & VLSI with 8+ years in production embedded firmware before this. We put that discipline to work for clients who need hardware that works the first time, and stays working.
Founder-led, hands-on
Every engagement is run directly by the person who designs the firmware — no account-manager layer between you and the engineer.
At a glance
Est. September 2025
Based in Chhatarpur, Madhya Pradesh
Focus Embedded · IoT · Computer Vision
Also runs an engineering internship / TNP program
§03 — SELECTED WORK
A vision system replacing a decades-old manual check.
For a commercial-trailer manufacturer, Enddrave is building a camera-based Wheel Alignment Vision System — replacing manual tape-and-thread measurement with a kingpin-referenced, drive-through inspection setup that reads thrust angle, scrub angle, and runout in seconds instead of manual measurement runs.
End-to-end ownership
Architecture, algorithms, field validation at OEM sites, and a production-track MVP with an operator-facing measurement app — one team from first design review to factory floor.
Project snapshot
Sector Commercial vehicle / trailer manufacturing
Replaces Manual tape-and-thread alignment checks
Approach Camera-based, drive-through measurement
Status Active engagement, in development
Client Confidential — under NDA